Submersible Motors 8 inches HD

8" submersible motors rewindable water fille HEAVY DUTY, rewindable in PE2+PA.

Heavy duty construction for longer operating lifeand high reliability. With mechanical seal (graphite - ceramic) winding PE2+PA for temperatures up to 50°C.

8" motors from 30 kW up to 110 kW.

Motor shaft in AISI 431 B. Sensor Temperature PT100. Duplex Available on request also in AISI 304,AISI 316, DUPLEX.

Manifacturing features

• Stainless steel sleve
• Upper and lower supports and base in G 25 cast iron. Fully stainless steel version available in AISI 304, AISI 316, Duplex and AISI 904 - NEMA coupling
• Thermoplastic protection of winding copper wire are used in the statoric part, upon request PE2+PE winding wire for higher water temperatures
• Isolation class F
• Protection IP68
• Rotor with AISI 431 shaft, bearing bushes in carbide (upon request available in BSPB15% bronze). Thrust bearing Mitchell type suitable to withstand the maximum load with very high safety standards.
• Compensation diaphragm able to equalize inner and outer pressures and related variations due to the temperature spectrum during the motor functioning in the well.

Characteristics

• Available in 50 Hz and 60 Hz versions
• Maximum number of starts per hour: (6’’:15)
• (8’’ :10)
• (10’’: 10)Water maximum temperature: 30°C
• with PE2+PA winding up to 50°C
• Axial load 6’’: 16.000 N from 4 to 15 kW25.000 N from 18,5 up to 37 kW . Axial load 8’’: 45.000 N from 30 up to 110 kW
• Axial load 10’’: 60.000N from 75 up to 184